CDC160 DVD Case Wrapper
TP 000 103 - 8 -
SECTION 3: OPERATION
3.1 Powering Up
After connecting to the power supply, power up the
CDC160
using the switch situated on the side
of the machine.
The commands on the front panel of the machine are as following:
1 - "Start/Stop" push button and indicator
2 - "Rest Default" push button and indicator
3 - "Front Heater" potentiometer & indicator
4 - "Side Heater" potentiometer & indicator
Switch on the CDC160 and allow the heaters to stabilize for approximately 15 minutes.
When the machine is switched
ON
, both temperature indicators (3 & 4 above) must be
ON
.
If this is not the case not, using a screwdriver, turn the potentiometer clockwise until the light goes
ON
.
3.2 Adjustments
The CDC160 has been pre-set with temperatures of heaters and cycle times suitable for a typical
DVD case. Under normal circumstances the temperature settings should not require adjustment,
however should difficulty in obtaining a reliable weld be experienced, the settings may be adjusted
via controls on the front panel.
Note:
Care should be exercised not to set an excessively high temperature, which may result in
damaged cases.
3.2.1 Adjusting the Side Heater Control
The side heater control varies the temperature of the side heaters and should be used in
conjunction with the timer control. Clockwise rotation increases the temperature.
3.2.2 Adjusting the Front Heater Control
The front heater control varies the temperature of the front heater used in the first stage of
the wrapping and will determine how long the heater is held manually in contact with the
case. Clockwise rotation increases the temperature.
3.2.3 Adjusting the Side Seal
Figure 1
