SECTION 4 - MACHINE OPERATION
3121636
– JLG Lift –
4-29
•
When approaching the loading surface, before the
change in inclination, ALWAYS check that the JIB arm is
COMPLETELY RETRACTED. Then proceed with great care
in order to prevent sudden jolts when passing from the
sloping ramps to the truck/trailer flatbed;
•
Position the machine so that none of its parts protrude
from the transport vehicle.
UnLoading
Unload the machine following the same instructions given
above.
•
During travel and when changing slope, make sure not
to damage the safety devices positioned under the bas-
ket.
•
If the change in inclination is excessive, adjust the angle
of the ramps or, if this is not possible, use longer ramps.
It is also possible to use the jib arm as described earlier.
Tie Down
WHEN TRANSPORTING THE MACHINE, THE BOOM MUST BE FULLY LOW-
ERED INTO THE BOOM REST.
•
Travel up ramps with the platform behind the machine.
•
Do not contact the ground with the jib or bottom of
platform when loading/unloading. Operate the
machine from the ground remote position and raise the
jib to prevent contact with the ground. See “Jib Position
for Travelling” on page 4-10.
•
ALWAYS load/unload the machine with the track fully
widened.
1.
Configure the machine to the transport position;
a.
place the booms in the stowed position and
properly aligned
b.
all outriggers are fully retracted
c.
tracks are fully widened
d.
remove all loose items from the machine
2.
Secure the chassis using straps or chains of ade-
quate strength.
DO NOT MAKE CONNECTIONS AT POINTS DIFFERENT THAN THOSE IDEN-
TIFIED BY THE TIE DOWN LOCATION DECAL SHOWN - SEE FIGURE 4-9.
THIS COULD CAUSE PERMANENT DAMAGE RESULTING IN THE COLLAPSE
OF THE PRODUCT.
To
order go
to
Discount-Equipment.com