If you wish to rotate the speaker’s grille/logo badge
alignment, remove the six #8 x 1-1/4” speaker mounting
screws and #8 Flat Washers.
9
For best adhesion, it is recommended to clean the inside
of the aluminum cap with acetone (not included) prior to
attaching it to the enclosure. Apply a circular bead of
silicone adhesive to the inside of the aluminum logo cap,
about 1/2-inch (13 mm) from the outer edge.
11
Align the aluminum logo cap to the desired angle of
rotation, and press it onto the back of the enclosure.
Apply masking tape (not included) to hold the cap in
place until the silicone cures (at least 24 hours).
12
Rotate the speaker to the desired angle. Reinstall the
speaker and speaker mounting screws and washers.
Hand-tighten in a criss-cross pattern.
10
