Apply Loctite® red thread-locking compound to two M6
x 16 mm Machine Screws, slide them through the slots
in the clamp receiver, into the appropriate holes in the
fixture base, and fully tighten.
5
Realign the clamps with the clamp receiver on the
enclosure, and secure them to the clamp receiver using a
pair of M6 x 45 mm Machine Screws, M6 Flat Washers,
and M6 Locknuts as illustrated, and fully tighten. Note:
The locknut should be installed into the hex shaped
recess on one end of each clamp.
7
Remove the center M6 x 16 mm Machine Screw from the
clamp receiver, apply Loctite® red thread-locking
compound, reinstall, and fully tighten.
6
Remove adhesive backing and install the JL Audio logo
badge.
8
