| Fathom
IWS
Page 16
Route the Speaker Cable
Route speaker cable into the
bottom of the wall cavity through
an adjacent stud and remove the
outer jacketing to expose the
individual wires. Two rubber covers
are included to insulate the speaker
terminals. Feed the individual
wires through each rubber cover
and remove the wire insulation.
While observing correct polarity,
connect the individual wires to the
push terminals located at the bottom
of the enclosure, then slide a rubber
cover over each terminal.
(Figure 20-22)
Note: To reduce the potential
for unwanted noise and vibration,
position the individual wires so
they do not come into contact with
any surrounding parts (enclosure,
mounting brackets, studs, wallboard
surfaces or any other surfaces within
the wall cavity). Any contact point
may lead to undesirable rattles or
buzzing, which will be inaccessible
once the surrounding wallboard has
been installed.
Figure 21
Figure 20
Figure 22
Summary of Contents for FATHOM IWS-SYS-108
Page 1: ...Enclosure Installation Manual IWS SYS 108 IWS SYS 208...
Page 2: ......
