| Fathom
IWS
Page 14
Set the Enclosure’s Final Position
Slide all four L-Brackets inward,
then place the enclosure into the wall
cavity, supported on the floor by the
Enclosure/Floor Stand (Part D). Both
Stud Mounts (Parts B & C) should be
pressed against the stud faces.
Using a level and the ends of
the Stud Mounts (Parts B & C)
as guides, adjust the enclosure’s
horizontal position to the middle
of the wall cavity. Centering the
enclosure’s position within the
wall cavity, so that no sides of the
enclosure are in contact with the
studs, will reduce the potential for
unwanted noise and vibration.
Install two #8 x 2-inch black
pan head screws through the guide
holes located at each end of the Stud
Mounts (Parts B & C) to set the
enclosure’s position. Select the guide
hole locations that will place each
screw at or near the center of each
stud.
(Figure 12 & 13)
Uninstall the four #8 x 1.25-
inch wafer head screws from the
Enclosure/Floor Stand (Part D)
and remove it for recycling.
Figure 13
Figure 12
Summary of Contents for FATHOM IWS-SYS-108
Page 1: ...Enclosure Installation Manual IWS SYS 108 IWS SYS 208...
Page 2: ......
