7
DIAGRAM E:
Flush-Mount Tweeter Installation
<
OR
>
FLUSH-MOUNT INSTALLATION
1) Detach the preinstalled surface-mount fixture
by inserting a small flat screwdriver into the
slots behind the tweeter flange and carefully
pry open to release.
2) Remove the vehicle panel and check the
desired mounting location to ensure that
there is adequate
clearance behind the
panel for the tweeter’s magnet structure and
mounting hardware.
3) Carefully cut a 1-3/4-inch (44 mm) diameter
hole in the vehicle panel. This will achieve a
snug fit and allow the tweeter flange to conceal
the cut line.
4) Select a suitable length stud bolt for your
panel’s thickness and screw its short end into
the rear of the tweeter using the fixed M4 nut
to tighten.
5) Insert the tweeter from the front of the panel
(do not attach the spring clip at this time).
6) Attach the spring clip from behind the
panel using the supplied
M5 nut and
tighten by hand until the tweeter is tight
on the panel. Do not overtighten.
8) Connect the tweeter’s wires to the supplied
harness with the in-line high-pass filter,
observing correct polarity.
9) Re-install the vehicle panel, taking care to
route the new wiring so as not to interfere
with any vehicle mechanisms (window
mechanisms, for example).
Stud bolts are provided in two lengths to accommodate different panel thicknesses.
10 mm length
25 mm length
