6
| JL Audio - C1-100ct Owner’s Manual
DIAGRAM D:
Surface-Mount Tweeter Installation
CLICK!
SURFACE-MOUNT INSTALLATION
1) Remove the vehicle panel and check
to ensure that the mounting screws
will have adequate clearance.
2) Place the surface-mount fixture on the
vehicle panel at the desired mounting
location with the mounting screw holes
positioned vertically, at twelve and six o’clock.
3) Mark the location of the two mounting
screw holes and the approximate center of
the right rectangular cutout (for the wires).
4) Using a 1/16-inch (1.5 mm) drill bit,
drill a pilot hole through the panel
at the two screw locations.
5) Using a 1/4-inch (6 mm) drill bit, drill
the hole for the tweeter’s wires at the
location you marked in step 3.
6) Screw the surface-mount fixture to the
vehicle panel using the supplied #6
sheet metal screws (hand-tighten).
7) Feed the tweeter wires through the
rectangular hole in the mounting fixture and
the 1/4-inch hole you drilled in the panel.
Then, snap the tweeter into the surface-
mount fixture.
8) Connect the tweeter’s wires to the wire leads
from the crossover, observing correct polarity.
9) Re-install the vehicle panel, taking care to
route the new wiring so as not to interfere
with any vehicle mechanisms (window
mechanisms, for example).
