3
C1-100ct SPECIFICATIONS
Continuous Power Handling:
60 Watts
Recommended Amp Power:
20-60 Watts / ch. (RMS)
Efficiency:
91.5 dB @ 1W / 1m | 97.5 dB @ 1W / 0.5m
Sensitivity:
94.5 dB @ 2.83V / 1m
Nominal Impedance:
4 ohm
Frequency Response:
3.6 kHz - 22 KHz ± 3 dB
Tweeter:
Edge-driven, silk-suspended aluminum dome
1.0 in. (25 mm) diameter diaphragm / voice coil
Ferrofluid cooling / damping
Neodymium Magnet
Crossover:
2nd order, high-pass filter with inductor and
electrolytic capacitor
Included Components and Parts:
• Two (2) C1-100ct 1.0-inch (25 mm) tweeters
• Two (2) surface-mount tweeter fixtures
• Two (2) C1-100cthp in-line, high-pass filters on
4 ft. (1.2 m) wire harnesses
• Two (2) metal spring clips (for tweeter flush-mounting)
• Four (4) #6 x .625-inch (22 mm) sheet metal screws
• Two (2) 10mm stud bolts with fixed M4 nut
• Two (2) 25mm stud bolts with fixed M4 nut
• Two (2) M5 nuts
GETTING STARTED
• Turn off the audio system. It is also
advisable to disconnect the negative
(–) terminal of your vehicle’s battery
whenever performing installation work.
• Before cutting, drilling or inserting any screw,
check clearances on both sides of the planned
mounting surface. Also check for any potential
obstacles, such as window tracks and motors,
wiring harnesses, etc. Check both sides of the
vehicle, many vehicles are not symmetrical!
• Always wear protective eyewear.
