12W7-3
Free Air Resonance (Fs):
27.2 Hz
Electrical “Q” (Qes):
0.514
Mechanical “Q” (Qms):
7.807
Total Speaker “Q” (Qts):
0.482
Equivalent Compliance (Vas):
2.33 cu. ft. (66.0 ltrs)
One-Way, Linear Excursion (Xmax)*:
1.15 in. (29 mm)
Thermal Power Handling (Pt):
1000 Watts Continuous
Reference Efficiency (no):
0.249 %
Efficiency (SPL @ 1W/1m):
86.2 dB
DC Resistance (Re):
2.47Ω
Effective Piston Area (Sd):
84 sq. in. (0.0542 sq. m)
Nominal Impedance (Znom):
3Ω
* Xmax specifications are derived via one-way voice coil overhang method with
no correction factors applied.
Infrasonic Filter:
Turn
for
.
Turn
for
and
set the knob to
Hz.
Bass EQ:
Generally not necessary in W7 applications (we recommend defeating it by
switching the
&
switch to
). May be used with Remote Bass
Control to provide some user controllable broad bass boost. When used in this
manner, set
&
to
, set
-
to
Hz,
is defeated by
connection of Remote Bass Control.
Input Sensitivity Controls:
Proper adjustment of these controls is critical!
For virtually all aftermarket head units,
set
#,'*
to
$/
.
See
#,++.+0+*!+
on pg. 14 for precise setting instructions.
Dual Mono Speaker
Output Connections:
Connect wire directly to
and
2(/),
connections and to the W7.
Remote Bass Port:
Permits connection of an
optional remote bass boost
controller (RBC-1), giving you
control over the boost of the
parametric EQ from the front
of the vehicle. The RBC-1
controller is sold separately.
Amp Low-Pass Filter:
Set
%,
switch to
.
Set
+ -"1
knob to
.
Lower settings are likely to result in a
poor transition between the upper
response of the W7 and the lower
response of the mid-bass speakers.
Amplifier Input:
Connect RCA-type
cables from the head
unit (or processor) to
these two jacks.
Use both jacks
(with a Y-adapter
if necessary).
Output Polarity:
Carefully listen to the sub-bass to
mid-bass transition with music that
has strong mid-bass content. Select
the switch position which gives the
smoothest, most natural mid-bass
response. If using multiple 1000/1’s
on multiple subwoofers, make sure
this switch is set to the same position
on all amplifiers.
JL Audio 1000/1v2:
These settings are intended
as a “baseline” for tuning your
system. Depending on your
vehicle and your preferences,
some variation in the crossover
and bass control settings may
be necessary for optimum
performance.
(See settings
on page 10 for 500/1.)
RECOMMENDED CONTINUOUS (RMS) POWER RANGE FOR ONE SUBWOOFER DRIVER:
5 0 0 W
7 5 0 W
1 0 0 0 W
2 0 0 0 W
2 5 0 W
= position of knob
= position of switch
= switch with two possible positions
= setting will vary (see sidebar)
Amplifier Recommendation:
1000/1v2 (pictured), HD750/1,
500/1v2 or G-MAX
8
Summary of Contents for 10W7-3
Page 1: ...Owner s Manual...
