JKEXER Turbo 772, Owner'S Manual

Page: 8 / 24

6
Step 1.
Step 2:
FRONT POST
CROSS BAR
WARNING
CROSS BAR
CABLE
FRONT POST
CROSS BAR
BOLT (B)
BOLT & WASHER (A)
Warning:
And please note when inserting the Cross Bar into the hole on Front
Post , the cables inside Front Post would not be compressed or cut
off.
Please note there are 2 Front Posts (2),
right and left. The right post is with 2
cables at the bottom and 3 cables at the
top. And the left post is with only 1 cable
at the top. Well connect 2 cables from the
bottom of right post to the cables from
Main Frame (1), then insert this right post
onto the U-bracket on the right side of
Main Frame (1). Also insert left post onto
another U-bracket on the Main Frame (1).
Do not put the bolts yet.
PHOTO (2-3) PHOTO (2-1)
PHOTO (2-2)
2-1. Attach Cross Bar (4) to two inner
sides on both Front Posts (2) as
photo shown . Please be careful
not to scratch the paint off.
2-2. Then use Bolt+Washer (A) to go
through Front Post (2) to screw into
Cross Bar (4).
2-3 Use Bolt (B) to fix Cross Bar (4) onto
Front Post (2).
MAIN FRAME
FRONT POST