JKEXER Turbo 772, Owner'S Manual

Page: 6 / 24

How to lubricate?
Follow below drawing, lift running belt as high as possible, wipe the deck and the edge of the
belt with a clean lint free cloth to remove any dirt on both sides. Then inserting straw from
silicone bottle from either side of the running belt to reach to the deck surface about 18 inches
from motor cover, pump out the silicone of the tube across the deck, parallel to the motor cover,
in about one foot line. The one foot line should be in the middle of the deck at approximately
equal distance from both side edges of the belt. Repeat above procedures to distribute onto 3
spots on the running deck as shown on drawing. Once the silicone is applied, you should walk,
not run, at low speed on the treadmill for at least 5 minutes to ensure it is evenly distributed.
You want the lubricant to be applied about the spot that your feet would hit the belt as you are
walking. This should be about 18 inches from the motor cover. You may walk
on the treadmill to see where your feet land on the belt. Please note if you mostly run on the
treadmill, the spot where your feet land may be different from the spot in walking.
Note:
1. IF belt is stuck under side rail, use a screwdriver to lever out for easy lubrication
2. IF belt is not centered, please refer to P. 18 --- Aligning The Running Belt
.
Remarks: If static symptom happens, adding silicone on the running deck will also help
solve it.
What to lubricate?
Do not lubricate with other than our approved lubricant. Your treadmill comes with one 30ml
tube of silicone. For further lubrication, you may order from distributor for our 200ml silicone:
• 200ml silicone in one bottle with 35cm applicator
•
100% silicone, non-petroleum base, contains of no harmful solvents, non-toxic and
nonflammable
• Pump action spray bottle
•
Good for treadmill that used non-petroleum based lubricant
1
2
3
4