Operating
(Continued)
Handset Jack
The handset jack on the side of RemoteMix C+ allows you to
plug in a telephone handset and quickly set up a call before
you set up your microphones and headphones. The
handset microphone volume is adjusted using the
Line In
knob. The earpiece volume is adjusted using the
Headphone
level knob. All telephone handsets are different,
so if yours is not compatible, try an AT&T, Sony, or Radio
Shack residential phone handset.
Keypad
The telephone keypad is for tone or pulse dialing. You may
use the keypad at anytime during a call but keep in mind that
both transmit and receive audio are muted during a
keypress.
Tone / Pulse Dialing
RemoteMix C+ is equipped with a switch to select tone
(DTMF) dialing or pulse dialing. The switch is located
underneath the battery door. With the switch towards the
volume control knobs, the unit is in the “pulse” mode. When
in “pulse” mode the “*” key will set the unit to transmit digits
as tones regardless of the switch position. To return to
pulse dialing turn the power off and back on.
Phone Line Switch
This switch acts as the switch-hook for the telephone line.
The
Hang Up
position is the normal on-hook position when
you are not using the line or you are waiting for a call. When
you want to place a call, or when a call comes in, switch to the
Dial/Talk
position
Operating
(continued)
Ringer
RemoteMix C+ has an internal ringer for incoming calls.
This can be turned off using the switch on the side of the
unit.
Power
RemoteMix C+ is powered by two 9 volt alkaline batteries
located under the cover on the bottom of the unit. Under
normal use, you should get at least 30 hours of continuous
use from a fresh set of alkaline batteries. To test the
batteries, simply press the
Battery Test
button on the front of
the unit. If the LED lights, the batteries are still good. The
unit may still function if the LED does not light, but there will
be significant audio distortion and a loss of level as the
batteries continue to discharge. The batteries are wired in
parallel so it is important to replace both at the same time
with identical batteries. If two fresh batteries are not
available, it is better to run using only one good battery.
Since the two battery fixtures are wired in parallel so it does
not matter which one gets the single battery. We also
provide a high quality, regulated AC to DC adapter to power
RemoteMix C+ when AC power is available. Simply plug it
into the back of RemoteMix C+ and plug the transformer into
a 110 VAC wall outlet. When the power connector is inserted
into the jack, the batteries are bypassed. The AC adapter
does not charge the batteries.
4
5
