background image

Operating

 

Send Side (To Phone Line)

There are separate volume controls for the two microphone 
inputs and the line input (

To Phone Line

) jack.   You can use 

all three inputs at the same time. Mic 1 also has a Mic/Line 
selector switch which lowers the gain on the Mic 1 XLR jack 
by 30 dB to allow a balanced line level input.

Receive Side

 

(From Phone Line)

The receive side has separate controls for headphone output 
level and tape receive output level.

  

The 

Line Out

 control 

adjusts the signal going out the RCA and XLR jacks marked 

From Phone Line

. This is a mix of both sides of the telephone 

call.

Headphones

The built-in headphone amplifier is strong enough to power 
two pair of headphones or a small desktop speaker.  The left 
and right channels contain the same mono signal, but are 
powered by separate amplifier channels.  These jacks will 
drive either two 1/4" stereo plugs or two 1/4" mono plugs.

Connections

RemoteMix C+ is a professional audio mixer designed to 
work on any standard analog telephone line.   It can also 
connect to many cellular telephones using a fax/modem 
adapter available from your cellular telephone 
manufacturer. Simply plug your audio equipment into 
RemoteMix C+ and connect to a phone line.   You can now 
put on headphones, plug in a microphone, and you are ready 
to broadcast the game or talk up a taped interview.  The RCA 
type jacks on RemoteMix C+ are equivalent to the jacks 
found on most home tape recorders, CD players, and 
receiver/amplifiers. The balanced line XLR jack provides a 
high quality connection to mixers and professional tape 
gear.  The adjustable hybrid circuit provides control over the 
mix of transmit and receive audio at the output jacks.     

1.

Connect your audio equipment, microphone, and 
headphones to the input and output jacks on 
RemoteMix C+.

2.

Connect the jack marked "Phone Line" to any 
standard analog telephone line or to the Fax/Modem 
adapter on a cellular telephone.

3.

Turn on the power switch, flip the "Phone Line" switch 
to "Dial/Talk" and dial your call.   You are now ready to 
broadcast or record a telephone interview.

Cellular Telephones

RemoteMix C+ was designed to work well with the data 
interface (fax / modem adapter) for your cellular telephone, 
available through your cellular dealer.  These adapters turn 
your cellular telephone into an RJ11 equivalent jack which 
replaces the wall jack in this picture. 

Audio Equipment
RCA or XLR
Input or Output

Microphone(s)

Headphone(s)

To wall jack

2

3

Summary of Contents for RemoteMix C+













Reviews: