-14-
Module type
Dimensions
（
mm
）
Maximum designed mechanical load : 3600Pa
(positive ) & 1600Pa (negative)
Frame
A*B
Group 1
40
1984*998 & 1984*992
2009*1008 & 2023*1018
Group 2 & Group 7
40
2000*992 & 2031*1008 & 2054*1018
Group 3
35
1674*998 & 1686*1008
1699*1018 & 1656*992
Group 4 & Group 8
35
1698*998 & 1680*992
1704*1008 & 1727*1018
Group 5
40
1974*998
Group 6
35
1664*998
Group 13
30
2223*1025 & 2255*1032
Group 19 & Group 20
30
1701*1122 & 1717*1132
1719*1134 & 1669*1122
1685*1132 & 1678*1134
Group 21 & Group 22
30
1884*1122 & 1901*1132
1904*1134 & 1868*1134
1865*1132 & 1848*1122
Group 23 & Group 24
30
2027*1122 & 2046*1132
2049*1134 & 2089*1134
2086*1132 & 2067*1122
Group 25 & Group 26
30
2274*1134 & 2278*1134
& 2230*1134
Group 27
30
2385*1122 & 2393*1130
2408*1132 & 2411*1134
Group 28
30&35
2465*1134
Table 5: Mechanical dimensions when modules installed with bolts fitting method
Note
：
The installation method of bolt fitting is based on the experimental results inJinko.
2.3.2.2 Fixation with clamps at long sides of frames
The module clamps should not come into contact with the front glass and must not deform the
frame. Be sure to avoid shadowing effects from the module clamps. The module frame is not to
be modified under any circumstances. When choosing this type of clamp-mounting method,
please be sure to use at least four clamps on each module, two clamps should be attached on
each long sides of the module. Depending on the local wind and snow loads, if excessive
pressure load is expected, additional clamps or support would be required to ensure the module
can bear the load. The applied torque value should be big enough to fix the modules steadily
(Please consult with the clamp or support’s supplier for the specific torque value). Please find
detailed mounting information in the below illustration, the mounting place distance is suggested