Jigsaw provide the solution piece by piece
Feel the Future of Heating. Step out of the Shade and into the Sun
10
11
400W WALL INSTALLATION
800W & 1000W INSTALLATION
400w heaters - One mounting
bracket must be used per installation
(Supplied)
The brackets on the Aluminium
heaters are suitable for wall and
ceiling mounting.
1, Attach the panel bracket (B) to the rear
of the heater with the four 10mm screws.
Ensure that they are tight.
2, The wall bracket (A) is attached to the
wall on 4 corners. This must be done at
a suitable height and position with the
correct fixings for the construction of
wall. Use a spirit level to ensure that the
bracket is straight.
3, Insert the grub screws into the wall
bracket ensuring that the screw is only
2-3mm in to the bracket.
4, The panel, with bracket (B) attached to
the heater, can then be slid into the wall
bracket (A).
5, Both retaining grub screws must
be tightened to ensure that the
heater is safely fixed to the wall (C).
Use supplied 350mm screwdriver (retail
customers)
Panel Bracket (B) into heater
Joined Brackets with grub screws (C)
Horizontal bracket positions for 800w & 1000w
One grub screw to be used in each bracket in the
outer left and right fixing.
Vertical bracket positions for 800w & 1000w
All four grub screws to be used on top and
bottom brackets
800w & 1000w heaters - Two mounting
brackets must be used per installation
(Supplied)
The brackets on the Aluminium
heaters are suitable for wall and
ceiling mounting.
1, Attach two panel brackets (B) to the
rear of the heater with the four 10mm
screws. Ensure that they are tight.
2, The wall brackets (A) are attached to
the wall on 4 corners. This must be done
at a suitable height and position with the
correct fixings for the construction of
wall. Use a spirit level to ensure that the
bracket is straight.
3, Insert the grub screws into the wall
brackets ensuring that the screw is only
2-3mm in to the bracket.
Horizontal -
Two retaining grub screws
must
be used.
Vertical - All retaining grub screws
must
be used.
4, The panel, with brackets (B) attached
to the heater, can then be slid into the
wall bracket (A).
5, Tighten the grub screw to ensure that
the heater is safely fixed to the wall (C).
Use supplied 350mm screwdriver (retail
customers)
