Jigsaw provide the solution piece by piece
Feel the Future of Heating. Step out of the Shade and into the Sun
8
9
INSTALLATION ADVICE
MOUNTING BRACKETS
•
Should not be installed in contact with the floor.
•
The equipment must not be located immediately below a
socket-outlet.
•
The equipment shall not be used if the panel is damaged.
•
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
•
Should not be installed in close proximity to flammable or
combustible materials or pressurised containers.
•
Make sure that there are no electrical cables or pipes in the wall
which could be damaged during installation.
Make sure the rawl plugs and screws used to mount the heater are
suitable for the wall type onto which the appliance is going to be installed.
If in doubt, ask professional qualified personnel.
The brackets on the Aluminium heaters are suitable for wall and
ceiling mounting.
The heater bracket provides the option of hanging your heater in either
landscape or portrait orientation. Rotate and fix to suit preferred position.
The wall bracket (A) is attached to the wall/ceiling on 4 corners. This must
be done at a suitable height and position with the correct fixings for the
construction of wall. See page 8 for measurements.
The panel bracket (B), attached to the heater, can then be slid into the wall
bracket (A). The retaining grub screws can then be tightened (C).
400w heaters - One mounting bracket must be used per installation
800w and above - Two mounting brackets must be used per
installation
Wall Bracket (A)
Mating Wall & Panel Bracket (B)
Joined Brackets (C)
Mounting (Advised)
1.5m to middle of heater from floor if wall
mounted.
Mounting (Mandatory)
0.50m to any surrounding objects
0.30m to any wall or ceiling (Minimum)
0.30m to any electrical socket (Minimum)
Must NOT block with any items,
clothing or furniture
