Jiffy Steamer Esteam J-Series, Owner'S Manual

Page: 23 / 42

1. Attach hose firmly with included assembly wrench,
which is magnetized and located on the bottom of the
unit (figure #1). Assemble and attach hose hanger rod
set (figure #2). See page 9 for assembly instructions.
2. Using supplied funnel, add a maximum of four quarts
of warm (fresh tap or distilled) water (cold water takes
longer to preheat). Do not overfill. Plug into proper
voltage outlet, turn switch to “PREHEAT”. Steamer
will hold at this temperature, and the light will go off
and on occasionally. NOTE: The J-4000 Steamer
contains a large water reservoir for 2 hours of
continuous steaming. Leave the switch in the
“PREHEAT” position (figure #3) if you plan to use
your steamer throughout the day. This will maintain
water temperature in the reservoir.
3. Immediately after water is preheated, turn switch to
“STEAM” position for steam in approximately 2 minutes. The combined
touch of the steaming head and the direct steam is very important. Some
articles can be steamed better from the underneath side. Always steam with
hose in upright position so any condensation is free to flow back into
steamer. If steaming in a low position near floor, straighten hose up and out
frequently to keep clear of condensation. If steamer runs dry it will
temporarily shut off. Once finished using the unit, turn the
switch to the “OFF” position. If more water needs to be
added to the steamer, allow steamer to cool before
removing fill cap and adding more water. Never pour cold
water on a hot element. Resume steaming by resetting the
switch to the “STEAM” position.
4. Hang steam head and hose in upright
position in the hose hanger section when
not in use (figure #4) and turn switch to
the “OFF” position (figure #3).
5. Periodically, pour old water out of steamer to avoid sediment
build up and maintain proper water level. Never have more
than 4 quarts of water in steamer. If overfilled, water will boil
up into hose. The Jiffy
® Liquid Cleaner is recommended
every 6 months to flush mineral deposits. See page 29 for complete cleaning
instructions.
WARNING: Never operate without water. Unplug after each use for added safety.
23
Jiffy ® J-4000 Directions
J-4000
Figure 1
Figure 2
Figure 3
Figure 4