Jiaxing Harley Baby Car HL228, Instruction Manual

Page: 18 / 23

12. DO NOT OPEN the battery or charger.
13. DO NOT CHARGE the battery backwards.
Always keep the battery dry. The battery must not get in contact with fresh or salt water.
Charging of the rechargeable battery
1. Before use for the first time you must charge the rechargeable battery for 12 hours, but no more than 24
hours. The battery must be charged by an adult only. Never allow a child to charge the battery.
2. Before plugging the adaptor for charging of the battery, you must turn off the power button.
3. When the normal speed of the jeep starts to significantly decline or after each use of the product, charge the
battery for 8-10 hours, but never more than 24 hours.
4. Check the battery, charger and their connectors and cables for extensive wearing or damage every time
before you start charging the battery. If you find any wearing or damage, do not use the charger or battery until
the worn or damaged part is replaced.
5. The battery must be charged in dry areas only.
6. It is normal for the battery and charger to become warm during charging.
7. Charge the battery at least once a month, even if the motor has not been used.
8. At room temperature under 5 degrees Celsius, the charging must take 3-5 hours more. Please, do not use this
product under - 5 degrees Celsius.
PARTS LIST
ASSEMBLY STEPS
WARNING! Children may get injured from small parts, sharp edges and tips on the unassembled jeep, or by the
electric components. Be careful when unpacking and assembling the BO jeep. Children must not take part in the
assembly or touch parts from the product, including the rechargeable battery.
Before you start to assemble the battery operated jeep, take the parts out of the packaging and check whether
all parts indicated in the list below are present. Keep the packaging until you have completely finished the
assembly. See
FIGURE PL:
Notice: Some parts may be pre-assembled at the factory. SEE FIGURE PD
No. Part Qty No. Part Qty
1 Hood 1 14 Tail light cover 2
2 Hood support 1 15 Rear bumper 1
3 Front bumper 1 16 Rear bumper support frame 1
4 Main body 1 17 Rear wheel 2
5 Windshield 1 18 Rear axle 1
6 Dashboard 1 19 Motor 1
7 Side mirror 2 20 Seat 1
8 Window 2 21 Door 1
9 Steering wheel 1 22 Hubcap 4
10 Backrest 2 23 Front wheel 2
11 Partition (horizontal) 1 24 Front axle 1
12 Partition (vertical) 1 25 Side pedal 2
13 Spoiler 1 26 Side support 2
A – Main body х 1
B – Steering wheel х 1
C – Side mirror х 2
D – Backrest х 2
E – Front wheel х 2
F – Rear wheel х 2
G – Window х 2
H – Seat х 2
I – Hood support х 1
J – Partition (horizontal) х 1 T – Rear bumper support frame х 1
U – Hubcap х 4
V – Screw х 1 (Ø5 х 38mm)
For the wheels:
W – Washer х 6 Ø(12х1.5mm)
X – Pin х 4
Y – Nut х 1 (5mm)
Z – Charger х 1 K – Hood х 1
L – Spoiler х 1
M – Left pedal х 1
N – Right pedal х 2
O – Partition(vertical) х 1
P – Windshield х 1
Q – Screw х 48 (Ø4 х 12mm)
R – Left side support х 1
S – Right side support х 1
17