7. Operation instruction of programming menu
In measurement display interface, keep pressing Menu button for more than three seconds until
appears, then press
or
button to switch to
. Now press
button to enter
program password interface. Press
or
button to input password (defaulted 0001), then
press
button to enter setting menu. (Note: if the password is not right,
will appear. Then it
returns to program password interface after seven seconds.)
7.1
Input primary value setting
User can change input primary value at field. After entering setting interface, press
or
button to select
, then press
button to enter signal setting interface, now press
or
button to select
.
Single phase voltage meter
change number
decimal
point
flashes
change the
position of
decimal point
k indication
light off
Three phase ammeter
change number
decimal
point
flashes
change the
position of
decimal point
7.2 Communication setting
E.g. Change communication address to be 3, set baud rate as 9600bps, change data format to be
no check mode.
After entering setting interface, press
or
button to select
, then press
to
enter communication setting interface, now press
or
button to select relative items.
