RL1 User Manual
13
M-RL1-001-01
Table 6: Detailed description of the RL1
Setup
page (see Figure 7)
Parameter
Description
Network Status:
•
If connected to a network via Ethernet, it will show as
Connected.
•
If not connected to a network, it will show as
Disconnected.
Device Name:
•
Product line (“
JGR-
RL1”
) and unit serial number (“
1932250
”
) as stored on
the unit.
IP:
•
If connected to a network via Ethernet, it will show the IP address of the
unit. Use this IP address to access the RL1 webpage or connect to it via
software.
•
If not connected to a network, it will show as
N/A
.
XN1 Location:
•
Shows the IP address (
“192.168.12.
53
”
) and port (
“8083”
) of the last
connected XN1 server.
•
If it hasn’t been connected, it will show as
N/A
.
●
Fast
○
Standard
RL acquisition speed:
•
Fast
: less than 1.5s per acquisition (recommended setting for most
applications).
•
Standard
: increased dynamic range (RL up to 85 dB) and increased accuracy
for RL > 70 dB.
●
<300m
○
<3km
RL length bin:
•
<300m
: faster measurement time
–
can measure
RL
A
,
RL
B
,
RL
TOTAL
and
length.
•
<3km
: the RL1 must wait longer for the laser pulse to return thereby
increasing the acquisition time
–
disables
RL
B
,
RL
TOTAL
and limits
length
measurement (1.2km for fast mode and 600m for standard mode).
●
Touch
○
Auto
RL acquisition mode:
•
Touch
: requires the user to tap on the
Measure
page to begin an acquisition.
•
Auto
: the system monitors the IL on one channel to automatically begin an
acquisition when a DUT is connected.
Selecting a Test Plan
Swipe right to access the
Test Plan Information
page (Figure 8).
Scan an XN1
test plan barcode while on this screen to load the plan onto the RL1. Please refer to the
XN1
Server User Manual
for more information.
To operate the RL1 without a test plan, tap and select
Manual
from the dropdown menu.
The following settings (see Table 6) from the
Setup
page are set automatically by the XN1 test plans:
•
RL acquisition speed
•
RL length bin
