10
Filament loading
Heat the nozzle:
Press and rotate the Control knob to
Prepare >Preheat PLA >Preheat PLA
END
to heat the nozzle according to the temperature range of the filament you are going to
use. (Reference Temperature: PLA: 200˚C, ABS: 240˚C)
Load the filament:
Once the nozzle reaches the target temperature, place the filament onto the
spool holder. Feed the end of filament through the filament sensor, then into the small hole at
the top of the extruder, until it comes out of the nozzle smoothly.
Note:
There are two extruder nozzles, load filament in each if you plan to use both.
1
2
3
4
5
Note:
The E2 height canbe adjusted a little up or down when there is needed. Note to loose
the four screws around, then to rotate the spring bolt to adjust the E2 height.