9
Conociendo el molino
MANUAL TÉCNICO DE OPERACIÓN - JF 15D
CENTRÍFUGA
TOLVA
PICO DE
ALIMENTACIÓN
FILTRO
FONDO
DE CORTE
ROTOR
CUCHILLA
MARTILLO
CABALLETE
PROLONGADO
* motor suministrado mediante pedido.
PICO DE SALIDA
INFERIOR
CABALLETE
CARCASA
CAJA DEL VENTILADOR
Español
22
Changing the hammers
Lubrication
There are 4 toothed surfaces on the hammers (A) which can be repositioned as each one
becomes worn.
Proceed as follows to change the hammer surface or to replace the entire hammer:
1- Cut the locks (B) on the hammer pins.
2- Remove the hammer pins (C), make sure the position of the rings is correct in the spacer
rings, and be careful not to mix the sets of hammers, as this will interfere with the balancing of
the machine, causing vibrations.
1- The only places where lubrication is necessary are
the bearing housings (D).
2- Lubrication must be weekly.
Lubricate the bearing housings with a grease gun (D),
using special grease for bearings, lithium soap base,
NLGI 2 EP classification. An example of this type of
grease is: LUBRAX LITH-2.
Before lubricating, clean the grease fittings well, in
order to avoid contamination from the grease.
Replace damaged grease fittings.
The most efficient time to lubricate is at the end of the
working period, as the grease will flow better while the
machine is still hot.
Summary of Contents for 15D
Page 2: ......
