31
Flow Control EMS
Flow control can prevent data loss from buffer overflow. When sending data, if
the receiving buffers are full, a
“stop” signal can be sent to stop the data flow.
Once the buffers are empty, a
“start” signal can be sent to re-start the flow.
Hardware flow control uses two wires to send start/stop signals.
The optional settings: [None]; [Hardware RTS/CTS]; [Software Xon/Xoff].
Data Bits EMS
The default setting is: [8].
*This item may or may not show up, depending on different configuration.
Parity EMS
The default setting is: [None].
*This item may or may not show up, depending on different configuration.
Stop Bits EMS
The default setting is: [1].
*This item may or may not show up, depending on different configuration.
USB Configuration
Press [Enter] to make settings for the following sub-items:
USB Configuration
XHCI Hand-off
This is a workaround for OSes without XHCI hand-off support. The XHCI
ownership change should be claimed by XHCI driver.
The optional settings: [Enabled]; [Disabled].
USB Mass Storage Driver Support
Use this item to enable or disable USB mass storage driver support.
The optional settings: [Disabled]; [Enabled].
USB hardware delays and time-outs:
USB transfer time-out
Use this item to set the time-out value for Control, Bulk, and Interrupt transfers.
The optional settings: [1 sec]; [5 sec]; [10 sec]; [20 sec].
Device reset time-out
Use this item to set USB mass storage device Start Unit command time-out.
The optional settings: [10 sec]; [20 sec]; [30 sec]; [40 sec].
Device power-up delay
Use this item to set maximum time the device will take before it properly reports
itself to the host controller.
‘Auto’ uses default value: for a root port it is 100 ms, for
a hub port the delay is taken from hub descriptor.
The optional settings: [Auto]; [Manual].
Select
[Manual]
you can set value for the following sub-
item: ‘
Device power-up
delay in seconds
’
,
the delay range in from 1 to 40 seconds, in one second
increments.
Network Stack Configuration
Press [Enter] to go to ‘
Network Stack
’ screen to make further settings.
Network Stack
Use this item to enable or disable UEFI Network Stack.
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
