29
The optional settings: [Disabled]; [Enabled].
Package C State Limit
Use this item to select the Maximum Package C State Limit Setting.
The optional settings: [C0/C1]; [C2]; [C3]; [C6]; [C7]; [C7S]; [C8]; [C9]; [C10];
[CPU Default]; [Auto].
[CPU Default]:
Leaves to Factory default value.
[AUTO]:
Initializes to deepest available Package C State Limit.
SATA Configuration
Press [Enter] to make settings for the following sub-items:
SATA Controller(s)
The optional settings: [Enabled]; [Disabled].
When set as [Enabled], the following items shall appear:
SATA Mode Selection
Use this item to determine how SATA controller(s) operate.
The optional settings: [AHCI]; [RAID].
M.2
Software Preserve
Port
Use this item to enable or disable SATA Port.
The optional settings: [Disabled]; [Enabled].
SATA
Software Preserve
Port
Use this item to enable or disable SATA port.
The optional settings: [Disabled]; [Enabled].
Hot Plug
Use this item to designate this port as Hot Pluggable.
The optional settings: [Disabled]; [Enabled].
PCH-FW Configuration
Press [Enter] to view Management Engine Technology Parameters information
and make settings in the following sub-items:
Firmware Update Configuration
Press [Enter] to make settings for ‘
Me FW Image Re-Flash
’.
Me FW Image Re-Flash
Use this item to enable or disable ME FW Image Re-Flash function.
The optional settings: [Disabled]; [Enabled].
* In the case that user needs to update ME firmware, user should set
‘Me FW
Image Re-Flash
’ as [
Enabled
], save the settings and exit. The system will turn off
and reboot after 4 seconds. If the user goes to BIOS screen again will find this
item is set again as [
Disabled
], but user can still re-flash to update firmware next
time.
Trusted Computing
Press [Enter] to enable or disable Security Device Support.
Configuration
Security Device Support
Use this item to enable or disable BIOS support for security device. TCG EFI
protocol and INT1A interface will not be available.
