6
SENATOR G2 MANUAL - HIGH PRESSURE CLEANER
The machine serial number is located on the frame. The
first letter & digits indicate the year and month of the
manufacture. (G = 2021 (Year), 4 = April (Month)).
NOTICE This machine is made high pressure water clean.
If properly used it should not damage a surfaces that is
in good condition and properly designed, constructed
and maintained. If the surface is in poor condition or not
properly designed, constructed or maintained, the water
cleaning process may not be effective or could cause
damage to the surface. The best way to determine the
condition of a surface before cleaning is through visual
inspection. Improper use of this pressure cleaner can
damage the unit and the surface. This machine may not
clear all substrate debris.
Machine Assembly
WARNING
To prevent serious injury during use and prevent
machine damage, follow these procedures for proper
assembly.
Engine Oil
NOTICE The unit is shipped with oil in the engine.
Operating the engine with low or no oil will result in engine
failure. See supplied engine operator’s manual for specific
information on checking oil, adding oil and oil selection.
Pump/Gearbox Oil
The unit is shipped with oil in the pump and gearbox.
Check oil level (ensure half way on sight-glasses) per
Maintenance section.
Wheels
Typically the unit is boxed and shipped with wheels
assembled. Wheels, Axles & Locking Collar are found
within the box. To assemble the wheels, slide axles through
axle location hole, slide wheels on each side find centerline
and proceed to install locking collar each side with 4mm
allen key tool. (if applicable)
Pre-Operation Inspection
WARNING
Before each use, inspect your pressure cleaner and
correct any problems to reduce the risk of serious
injury from high pressure water and other causes and
prevent unit damage. Always wear appropriate safety
equipment, when inspecting your unit.
1. Make sure that the battery isolator (if applicable) and
engine switch is in the OFF position.
2. Clean any oil, grease or dirt from the equipment,
including the handles and controls. This aids inspection
and helps prevent the machine or control from slipping
from your grip.
3. Inspect the high pressure cleaner and accessories for
the following:
• Proper assembly and completeness.
• Broken, worn, missing, misaligned, binding or loose
parts.
• Presence and readability of the warning labels.
(See Figure 4A.)
• Any other condition which may prevent the safe
and normal operation.
If any problems are found, do not use the unit until the
problems are corrected.
Figure.4A - Senator G2 Warning Labels
Clean water filter (Figure 5). Using the drain valve, drain the
tank. Unscrew the clear plastic bowl cover anti-clockwise
and remove and clean the mesh filter (note: ensure the
o-ring is set back into place before screwing plastic bowl
back on). Dirt and debris can restrict the water flow to the
pump and cause performance issues.
Figure.4B - Senator G2 Fuel Level Gauge
