12
9. Maintenance
Procedure
Daily
Weekly
Monthly
60 days
90 days
Clean all assemblies and components
thoroughly with dry cloth
X
If used in moisture weather. Remove the
machine from the transport box and leave
it to dry completely
X
Check/charge batteries in original charger
X
Inspect fasteners and screws
X
Check wheels for wear. Replace if excess wear
has occurred. Excessive wear has occurred
when the wheels are no longer able to
effectively grip the fiber optic
X
Duct pack seal replacement
X
Change rubber rings on drive wheel
Every 50 km unless excessive wear is occurring
Seals replacement
Every 10 km unless excessive wear is occurring
Wheel cleaning and tightening
Inspect wheel and tighten before and after each use. Clean after each
use, or when necessary
Disconnect power supply and exhaust any air pressure
before servicing any component on the MJET V0 HD.
Avoid handling leaking couplings, valve seal or
inadequately sealed pipe in air block.
DANGER! Risk of air under pressure penetrating skin.
6. Wheel drive engages forward
The wheel drive engages forward by the + button. By the – button the drive wheel will reverse. Please
note that the fiber protection system is disabled in reverse drive.
7. Observe
Set pushing force is reached by 40 % "speed/force %".
8. Disabling fiber protection
To disable the fiber protection system, press and hold “STOP” and “-“ button for 8 seconds. This will be
effective until next reset or power cycle of the machine.
Please observe: With the fiber protection the max. pushing is 200N.
9. Activate fiber protection
To reactivate the fiber protection system, press and hold “STOP” and “+“ button for 8 seconds or switch
on/off the main power supply.
