Jetter JX3-PS1, User Manual

Page: 20 / 24

Jetter AG Electrical connection | 6
JX3-PS1 User Manual 20 / 24
6.2 Ports and interfaces
6.2.1 Terminal X10 - Power supply
Ports and inter-
faces Terminal X10 lets you connect the following interface signals:
■ Power supply for up to 8 JX3 peripheral modules installed to the right of the
JX3-PS1 module.
Pin assignment
DC24V
1,0A
0V
P
O
W
E
R
Pin Description
DC 24 V
1.0A
Supply voltage for connected JX3 peripheral modules
0V Reference potential (GND)
6.2.1.1 2-pin connector, spring-cage technology
Category Description Standards
Connector
Designation BU_02_E_BLZF_GE_RM3.5
Connector technology Spring-cage connection
Type 2-pin, contact spacing 3.5 m
Connectible conductors
Outer diameter of the iso-
lation 2.90 mm max.
AWG 16 … 28
Terminal range 0.13 … 1.5 mm²
Stripping length 10 mm
Specification without wire end ferrules
Single conductor H05(07) V-U
0.2 … 1.5 mm²
Flexible conductor H05(07) V-K
0.2 … 1.5 mm²
Specification with wire end ferrules
Wire end ferrule without
sleeve 0.2 … 1.5 mm² DIN 46228/1
Wire end ferrule with
sleeve 0.2 … 1.5 mm² DIN 46228/4
Crimping tool PZ 4, PZ 6 ROTO, PZ 6/5 DIN 46228
Tab. 10: Connector specification, 2-pin connector, spring-cage technology
6.3 Functional test
After switching on, no configuration of the module is necessary.
To commission the JX3-PS1 module, carry out the following steps:
ü
The JX3-PS1 is connected to a JX3 station.
ü
The expansion modules to be supplied with power are connected to the right
of the JX3-PS1 module.
► Power up the JX3 station.
ð
The LED R of the JX3-PS1 lights up green if the commissioning has been
carried out correctly.