Jetter JC-975MC, Installation Manual

Page: 19 / 28

States of GP LEDs in AutoCopy mode
Level GP3 GP2 GP1 Description
1
Reset
2
Initialization
3
AutoCopy function is being executed
4
AutoCopy function is completed; no
errors occurred
5
AutoCopy function is completed; errors
occurred
Status LEDs
LED Color Description
THERM Red, flashing System is shutting down
due to overtemperature
DRIVE Green
HDD activity
SD Green
SD card activity
WD Red, flashing Watchdog timeout
PWR LED and PWR button
LED Color Description
PWR Green
Indicates that the
controller is energized
PWR button
The PWR button works as an ON/OFF switch.
As soon as voltage is applied to terminal X101, the
controller boots and the status LED PWR is lit
green. Depending on the position of the mode
selector (S11), the STX application program is
loaded (RUN) or not (STOP), or the AutoCopy
function is launched (LOAD).
Pressing the PWR button briefly has no effect.
Press and hold the PWR button (>4 seconds) to
force the unit to shut down. As this does not trigger a
power fail interrupt, the application registers in the
controller unit will
not
be backed up That's the
ON OFF OFF
OFF ON OFF
OFF ON 1Hz
OFF ON 4Hz
ON OFF 4Hz