Jetter JC-120MC, User Manual

Page: 73 / 634

Jetter AG 73
JC-120MC Mechanical and electrical installation
4.6 IP configuration
This chapter describes the IP configuration for the controller JC-120MC. The
following parameters can be set:
 IP address of the controller

Subnet mask
 IP address of default gateway
 IP address of DNS server

Controller name
 IP port number for the JetSym debugger
 Basic port number for communication via JetIP

Name for AutoCopy command file
To carry out IP configuration of the JC-120MC knowledge of IP networks is
required, such as

IP addressing (IP address, port number, subnet masks etc.)
 FTP (connection setup, data transmission, etc.)
Topic Page
Factory settings ............................................................................................ 74
The configuration memory ............................................................................ 75
The configuration file .................................................................................... 76
Configuration registers ................................................................................. 80
Changing the IP address of the controller .................................................... 81
Setting the default IP address 192.168.10.15 .............................................. 82
Setting the IP address via configuration file ................................................. 83
Setting the IP address via configuration file and DIP switch ........................ 84
Setting the IP address via registers to be non-volatile ................................. 86
Setting the IP address during runtime .......................................................... 88
IP address in the GNN operating mode ........................................................ 89
Using names for IP addresses ..................................................................... 91
Introduction
Required skills of the
network configurator
Contents