Jetter JC-120MC, User Manual

Page: 80 / 634

80 Jetter AG
4 Mechanical and electrical installation
Configuration registers
Configuration registers let you read the parameters of the IP configuration. A
range of registers holds the data contained in the configuration memory.
Another range contains the parameters used for initializing the IP interface.
The basic register numbers of both ranges are dependent on the device. The
register number is calculated by adding the number of the module register
(MR) to the number of the basic register.
Device Data range Basic register
number
Register numbers
JC-120MC Configuration
memory
101100 101100 ... 101165
Parameters
used
101200 101200 ... 101265
The following table lists the registers of both ranges, as well as their
connection to the entries in the configuration file /System/config.ini :
Register Section in
config.ini
Name in
config.ini
Description
MR 0 IP
Address
IP address of the controller
MR 1
SubnetMask
Sets the subnet mask
MR 2
DefGateWay
IP address of the gateway to other
subnets
MR 3
DNSServer
IP address of the server for the Domain
Name System
MR 32 HOSTNAME
SuffixType
The type of the automatically generated
suffix is attached to the controller name
MR 33
through
51
Name
Specifies the controller name
MR 64 PORTS
JetIPBase
IP port number for OS update and
communication between controllers
MR 65
JVMDebug
IP port number for debugger/setup in
JetSym
MR 80
FILES
AutoCopyIni
Name for AutoCopy command file
 The configuration memory (see page 75)
 The configuration file (see page 76)
Introduction
Register numbers
Configuration registers
Related topics