Jetter JC-120MC, User Manual

Page: 81 / 634

Jetter AG 81
JC-120MC Mechanical and electrical installation
Changing the IP address of the controller
To be able to communicate with the controller JC-120MC via Ethernet, you
must set an unambiguous IP address on the controller.
The IP address is stored to the backplane module. When you install another
controller of the JetControl 120 series to the backplane module, the following
configuration data are preserved:
 IP address of the controller

Subnet mask
 IP address of default gateway

IP address of DNS server
 Controller name
 Suffix type of the name

IP port number for debugger
 IP port number for JetIP
 Name for AutoCopy command file
You can configure the IP address in the following ways:
 Default IP address
 Configuration via file config.ini
 Configuration via file
config.ini
and DIP switch
 Configuration via the configuration registers

Configuration during runtime via special registers
Step Action
1
Remove power from the controller JC-120MC.
2 Remove the controller enclosure from the backplane module.
3
Make the corresponding DIP switch settings.
4
Reinstall the enclosure on the backplane module.

Following restart, the controller JC-120MC can be reached at the new
IP address.

Replacing the controller (see page 70)
 Default IP address 192.168.10.15 (see page 82)
 Setting the IP address via configuration file (see page 83)

Setting the IP address via configuration file and DIP switch (see
page 84)
 Setting the IP address during runtime (see page 88)
Introduction
Replacing the controller
Configuration options
Changing the IP address
Related topics