Jetter JC-120MC, User Manual

Page: 86 / 634

86 Jetter AG
4 Mechanical and electrical installation
Setting the IP address via registers to be non-volatile
The IP interface is initialized by the settings in the configuration memory
during the boot process.
The following non-volatile settings can also be changed via register:
 IP address of the controller
 Subnet mask

IP address of default gateway
 IP address of DNS server
 Host name and suffix type
 Port numbers for JetIP and the JetSym debugger
 Name for AutoCopy command file
Overview over the configuration memory registers:
Registers Description
101200
IP address
101201 Subnet mask
101202
IP address of default gateway
101203
IP address of DNS server
101232 Host name suffix type
101233 through
101251
Host name
101264 Port number for JetIP
101265
Port number for STX debugger
101280 through
101298
Name for AutoCopy command file
101299
Saving the settings (0x77566152)
To change the configuration values to become non-volatile, proceed as
follows:
Step Action
1
Enter the desired configuration into one or several registers within the
range from 101200 to 101298.
2
To have the controller take over the values, you must enter a password.
For this, write value 2002149714 (0x77566152) to register 101299.
3
Wait for the controller to write value 0 into MR 101299.
The save process is now completed.
4 Boot the controller.
Result: The settings are completed. Communication is possible again.
Introduction
Registers - Overview
Setting the configuration
values to be non-volatile