21
12. Working protocols for the treatments
1. Skin must be properly cleaned. Deep and surface cleaning are necessary to prepare the skin
for the absorption of plasma discharges.
2. Properly cleaned skin must be heated thoroughly, which causes dilatation of collagen
tissues. It is possible to use heating mask, heating by CryoJett device or by means of an
intensive manual massage together with the use of a suitable cosmetic product (for example a
serum based on the skin type). Cosmetic product is absorbed more easily due to the heat.
However, i tis necessary to check the temperature and reactions of patients skin.
!! BEWARE: Step 2 (heating) must be skipped when the treatment of couperosis is done,
the heat would dilate the vessels!!
3. In case of cosmetic treatments, apply a 1
–
2 mm thick layer of ultrasound gel on the treated
area with a help of brush or cosmetic spatula. Be especially careful around eyes and lips,
where the skin is very thin. If the patient feels an unpleasant tingling, add more gel.
4. Apply the plasma flow treatment. Move the tip of the device firmly, slowly and carefully in
the area of wrinkles, 1
–
2 mm above the gel, as you have been taught at the training. If bigger
areas are treated, use the flat applicator that touches the skin directly. Flat applicator should be
moved on the skin on which the indifferent gal has been applied.
Example of forehead wrinkles treatment:
Move the applicator at the straight angle along the line back and forth (
–––––––
) and
after that move the tip back and forth in the ZigZag way (/\/\/\/\/\/\/\/\).
5. It is recommended to apply a calming mask as an aftercare.
6. Working protocol for the evaporation of warts
The skin must be sterilized and it is recommended to use an anesthetic.
In this case, the discharges of the highest intensity (7 and 8) are applied and the spark flow
desirably destroys skin cells. Because the area of the sparkle beam is very small, the wart is
evaporated step by step and layer after layer, which enables a high precision of the destruction
and a subsequent coagulation.
7. Coagulation working protocol
–
stopping the bleeding in minor surgeries. The intensity
should be set at the level 7 or 8 and the doctor makes coagulation at the bleeding place, where
the blood transforms into a solid matter.