JETSURF G P, User Manual

Page: 25 / 47

48 49
5) When a mode has been selected, press the green button
START. The charger will beep and the battery charging will start.
The charging progress is displayed on the screen
– F I G U R E 7 .
If the battery is not connected or it is connected incorrectly or
if there is any other problem, an error message “CONNECTION
BREAK” will be displayed on the screen and the charger will
start beeping. Press START when asked to do so.
T I P : When the CELL button is pressed ( F I G U R E 7 ), the dis-
play will show the level of the individual cells – F I G U R E 8 .
7) When the battery is fully charged up, the display will read
Li-Po END and the charger will beep twice.
8) The STOP button will finish the charging process.
9) Disconnect the charging connector from the charger and
put the connector cover on the charging connector on the ig-
nition control unit (ICU) connected to the engine.
10) Disconnect the charger from the source.
Fully charge batteries last approximately two (2) to four (4)
rides depending on the style of riding.
N o t e : We recommend charging batteries continuously (for example when you have a break be-
tween the individual rides). Repeated short charging cycles do not affect the battery life. HOWEVER,
IN THE FIRST 5 CYCLES IT IS ABSOLUTELY NECESSARY TO CHARGE THE BATTERY TO ITS FULL
CAPACITY AND AVOID RAPID DISCHARGING TO THE MINIMUM LEVEL.
ALWAYS CHARGE THE BATTERIES BEFORE AND AFTER THE RIDE. AFTER TE RIDE, DO NOT
LEAVE THE BATTERIES FLAT. CHARGE THEM TO MINIMUM 50 % OF THE CAPACITY.
In winter or when not using JetSurf
TM
, it is necessary to charge the batteries in the ICU minimum once
in every 3 months.
BRIEF OUTLINE OF BATTERY CHARGING
MODE1: BAL. CHARGE Mode intended for charging after the last ride
of the day rides and
WHEN JETSURF
TM
IS
CHARGED FOR THE FIRST TIME
MODE2: CHARGE Mode intended for charging between
the individual
MODE3: STORAGE Mode intended for charging the JetSurf
TM
for storage
ENGINE STARTER
Please be aware that excessive use of the
starter may results in its overheating and
damage. IF THE ENGINE DOES NOT START
AFTER 5 ATTEMPTS, LET THE STARTER COOL
DOWN BEFORE TRYING AGAIN.
The same also applies to the situations when there is water in the engine. If the engine
starter does not run and the engine does not start correctly, stop trying to start it imme-
diately and perform the engine cleaning procedure according to the instructions on PAGE
66 of this user manual.
Starting of combustion engine with water inside the cylinder (drown engine) leads to
DESTRUCTION of starter and excessive use of ICU used for these starts distinctly lowers
lifespan of batteries. NEVER START JETSURF IF YOU HAVE DROWNED ENGINE.
DESCRIPTION OF PARTS DESCRIPTION OF PARTS
WARNING
F I G U R E 7
F I G U R E 8