Installation of the Front Wheel
1. Take out the front wheel, and loosen
the nut and hook on the front wheel axis.
2. Make sure the disc plate is inserted into
the disc brake notch. Place the front
wheel axis into the front fork contact pin,
as seen in the image to the right.
3. Place the washer on first, then tighten
the nut with a 15mm opening wrench.
NOTE: When fastening the nut, press down on the front fork so that the front wheel
axis can line up tightly with the front fork.
Installation of the Steering Handle
1. Take out the handle bar, and remove
the protective paper from above the
handle bar and stem.
2. Place the stem on the front of the
bike frame, and line it up with the front
wheel.
3. Tighten the stem with the 5mm hex-
agonal spanner, as pictured in
Step 1
.
4. Tighten the stem with the 6mm hex-
agonal spanner, as pictured in
Step 2
.
5. Place the handle bar in the stem and
tighten the four bolts with the 5mm hex-
agonal spanner, as pictured in
Step 3
.
6. Ensure that the thread position on the
handle bar is in the middle of the stem,
as pictured in
Step 4
. Tighten all bolts on
the stem and handle to lock all pieces
into place.
STEP 1
STEP 2
STEP 3
STEP 4
6
ASSEMBLING THE ELECTRIC BIKE
