Jets™ Opal Wall Toilet
Tel. +47 70 03 91 00
www.jetsgroup.com
Product No. TO615PO
Doc. Rev.: 4 (2019-01-18)
5
Pre-Installation
Standards and Regulations
To install a Jets™ product, it is first required that the room be prepared according to all local, state and federal standards and requirements.
Industry specific standards must also be met. Considerations that must be made include but are not limited to:
● Appropriate dimensioned drain pipes.
● Water barrier or membrane.
Installations required to meet AS/NZS 3500 series of Standards must adhere to the following:
(Ref: Australian and New Zealand Standards: AS/NZS 3500 - AS3500 Part 2 Sanitary Plumbing and Drainage )
● Discharge by a vacuum toilet system shall be regarded as "pumped discharge" and shall be pumped according to AS/NZ3500 "Pumped
Discharge" requirements.
● Installation of the vacuum toilet system shall be according to the requirements of AS/NZ 3500.2 Sanitary Plumbing and Drainage.
Tools and Training
No special tools other than those used in standard plumbing installations are required. No special training is required to install this product.
Water Barrier
Note that in some countries, and as per the majority of standards and regulations, it is prohibited to mount toilets directly onto the wall if mounting
requires that the water barrier be compromised. Check requirements according to local codes and standards before beginning any installation
work.
Pre-Installation Considerations
It is recommended that items such as wall mounted release buttons, drainage and piping etc. is installed prior to installation of the toilet.
The toilet is delivered with a fastening kit aimed at installation on existing wall mounted bolts. If you do not have existing wall mounted bolts, a
fastening kit that includes the mounting bolts may be purchased through your Jets Vacuum AS supplier.
Bolts should be installed on adequately dimensioned weight bearing studs or a suitable mounting frame. Ensure that mounting bolts are positioned
horizontally.
Connection with Mains Water
The toilet valve connection requires a 1/2" BSP standard connection. the water pressure must be a minimum of 2 bar and not exceed 7 bar.
Connection for Seat and Cover
A 1/2" cold water connection and a 230VAC power connection is required.
Connection placement is restricted by the hose and cord length. Refer to the data sheet for the seat and cover.
Backflow Prevention
Backflow Prevention
Please refer to local, state, federal and/or international regulations regarding the extent of backflow requirements for your specific installation.
For installations whereby the valve is to be connected to a drinking water supply, it is recommended that the water connection is installed with a
backflow prevention device. Please refer to the local regulations in your area. If backflow prevention is required in Australia, refer to AS/NZ3500.1
Backflow Prevention.
Pre-Installation Wall Preparation
The toilet is a wall mounted model which can be installed in locations where:
● a service hatch, cabinet or utilities room is available.
● the toilet bowl is to be removed from the wall for service.
For retrofit installations, contact your local approved supplier or Jets Vacuum AS for further information.
