Installation & Operation manual of Jetmaster Vent Free range
Page 10
Revision 01/09
OPERATION INSTRUCTIONS
GENERAL
Whenever a gas smell is detected, follow the following steps:
•
Switch the unit OFF.
•
Switch off the gas supply to the unit
•
Consult the fault finding guide in this manual
TURNING ON / OFF
The first step is to ignite the pilot burner. With the pilot burner in operation the gas supply to the main burner can be
turned on and off.
IGNITING THE PILOT BURNER.
NOTE: The pilot burner is located in the centre, at the back of the burner just under the top level of the burner.
Push in, and turn the valve knob anticlockwise. This will manually open the gas supply to the pilot burner and
generate a single spark. Keeping the knob depressed, it might be necessary to perform the turning action several
times to create several sparks until the flame ignites.
When the flame is established in the pilot burner, keep the knob depressed for at least another 10s. This allows the
safety valve to activate and to keep the gas supply to the pilot burner open.
Release the knob, and verify that the pilot burner is burning stable.
IGNITING THE MAIN BURNER.
Depress the valve knob and turn anticlockwise to the maximum flame position. This will open the gas flow to the
main burner which will be ignited by the pilot burner.
SWITCHING OFF
The burner can either be switched off completely, or only switched to a standby position with the pilot burner still
burning.
To switch off completely, depress the knob and turn clockwise all the way.
To switch to the standby position, depress the knob and turn clockwise to the position marked for standby. (see
section below)
If a gas smell is detected either when the unit is OFF or ON,
action must be taken immediately
Summary of Contents for 700 Vent Free Built in
Page 1: ......
