P
R
O
P
R
O
EN
Problem
Cause
Solution
The motor stopped
Automatically.
One or more of the controller
protections were activated
and the motor was stopped.
You will find the reason why
the
motor stopped in the
transmitter menu:
"Device Explorer" ->
"Mezon Pro" ->
"Telemetry" -> "Status"
After changing controller
mode nothing changes
(unidirectional <->
bidirectional).
The controller demands to be
power cycled to apply the
change.
Disconnect the battery from
the controller. Wait a few
seconds and connect the
battery to the controller.
The controller measures
revolution incorrectly.
The number of poles or the
motor gear ratio was set
incorrectly.
Set the correct number
of poles and motor gear
ratio in the transmitter menu
„Device Explorer" -
> "Mezon Pro" -> "Motor
Config"
.
The motor rotates in the
opposite direction.
Inappropriate combination of
cable connections to the
motor.
Exchange any of two cables
from the controller to the
motor.
Set the direction of rotation to
"Reverse"
in the transmitter
menu
"Device Explorer" ->
"Mezon Pro" -> "Motor
Config"
.
The BEC voltage did not
change after configuration
via the transmitter.
The change of the BEC voltage
must
be confirmed.
Confirm the item in the
"Device Explorer"-> "Mezon
Pro" -> "General Settings" -
> "Apply BEC voltage".
29
Summary of Contents for Mezon Pro
Page 2: ...P R O P R O P R O...
Page 30: ...P R O P R O P R O EN 30...
Page 45: ...P R O P R O P R O DE 45...