Jet JSMS-10L, Operating Instructions Manual, Page: 7 / 13

Fig 7
Bevel cutting:
Bevel angle can be adjusted between
0° and 45°.
The bevel lock knob (N, Fig 8) on the
rear of the machine must be loosened
for bevel setting.
Fig 8
Tilt the cutting head to the left until
the desired angle on the scale has
been reached.
Retighten the cutting head lock knob
before machine operation.
Mitre cutting:
The mitre angle can be adjusted
between -45° and +45°.
The 2 miter lock knobs (F, Fig 1)
behind the fence must be loosened.
Rotate the cutting head until the
desired angle on the table scale has
been reached.
Retighten the table locking knobs
before machine operation.
Mitre bevel cutting:
Select the correct bevel and mitre
angles.
7. Setup and adjustments
General note:
Setup and adjustment work may
only be carried out after the
machine is protected against
accidental starting by pulling the
mains plug.
7.1 Changing the sawblade
The sawblade has to meet the
technical specification.
Check sawblade for flaws (cracks,
broken teeth, bending) before
installation. Do not use faulty
sawblades.
The sawblade teeth must point in
cutting direction (down)
Always wear suitable gloves when
handling sawblades.
The sawblades may only be
changed when the mains plug is
pulled!
Remove the blade’s protective cover
by unscrewing the two screws (R, Fig
9) on the side and flip up the
protective cover (S).
Fig 9
Press the spindle lock button (U , Fig
3) and loosen the sawblade clamping
screw with the supplied spanner (T).
Attention: Left hand tread
Remove the outer clamping flange.
Replace the sawblade (J, Fig 1).
The teeth of the blade must point in
the same direction as the arrow on
the protective cover.
The flanges should be cleaned before
the new blade is fitted.
Fit the outer clamping flange back
into position and tighten the clamping
screw.
Reposition the plastic protective
cover and tighten the two screws (R,
Fig 9).
7.2 Laser Adjustment
The line laser (V, Fig 10) must be
adjusted so that the beam meets the
cutting line.
Use the screws (W) for adjustment
Fig.10
Attention:
Class 2 laser product, do not stare
into beam of laser.
7.3 Bevel Stop Adjustment
The 90° and 45° bevel stops are
adjusted ex works.
In case of need they can be adjusted
with the screws (X, Fig 8)
7.4 Cutting Depth Adjustment
The cutting depth can be adjusted
with the screw (Q, Fig2).
This allows a halve cut of the
workpiece when cutting with slide.
Attention:
After each adjustment check the free
movement of the sawblade before
switching on the machine.
8. Maintenance and inspection
General notes:
Maintenance, cleaning and repair
work may only be carried out after
the machine is protected against
accidental starting by pulling the
mains plug.
Repair and maintenance work on the
electrical system may only be carried
out by a qualified electrician.
Repair work on the laser beam may
only be carried out by a specialist.
Clean the machine regularly.
Inspect the proper function of the dust
extraction daily.