Jet JSMS-10L, Operating Instructions Manual, Page: 6 / 13

Fig 4
Use the clamping pieces (A) to lock
the table extensions (C) in place.
Mounting the dust bag.
Use the dust bag (K, Fig 1) to collect
the dust emissions. You can slide the
dust bag onto the dust port on the
rear of the machine.
The dust port is also suitable for the
connecting to a dust collector.
Unlocking the cutting head .
The mitre saw is supplied with the
cutting head in locked position. The
cutting head lock button (D, Fig 2)
can be pulled out by pushing the
cutting head down at the same time.
Allow the cutting head to slowly rise.
The cutting head should be relocked
for transportation.
5.3 Mains connection
Mains connection and any extension
cords used must comply with
applicable regulations.
The mains voltage and frequency
must comply with the information on
the machine licence plate.
The mains connection must have a
10A surge-proof fuse.
Only use power cords marked
H05VV-F
Connections and repairs to the
electrical equipment may only be
carried out by qualified electricians.
5.4 Starting operation
You can start the machine by
pressing the trigger (B, Fig 1) on the
handle with your fingers.
To stop the saw release the trigger.
6. Machine operation
Correct working position:
In front of the machine standing in the
direction of cutting (Fig 5)
Fig 5
Keep your face and body to one side
of the blade, out of line with a
possible debris throwback.
Never cross your arms or place your
hands near the cutting area
.
Don’t overreach; keep good footing
and balance.
Do not cut short workpieces.
You cannot properly hold a short
workpiece.
Workpiece handling:
Support long workpieces with helping
roller stands.
During cutting operation the
workpiece must be locked down to
the table with the workpiece clamp.
Do not perform any operation
freehand.
Operating hints:
Always observe the safety
instructions and adhere to the
current regulations.
Set up mitre and bevel cut as desired.
Plug in (connect to mains).
Ensure that the saw blade protective
cover is in the correct position before
you start sawing.
The mitre saw is switched on by
means of the trigger button that is
situated on the inside of the handgrip
(B, Fig 1).
The cutting blade must first reach the
maximum rpm before cutting may
begin.
Cutting without slide:
(slide locked)
Slide the unlock button (P, Fig 2) to
the side and by using the handgrip,
push the cutting head slowly and
evenly downwards.
The cutting head must be returned
carefully to its starting position after
cutting.
Cutting with slide:
For cutting wider stock slide action is
necessary.
Loosen slide lock knob (L, Fig 1).
Pull the motor head towards you.
Slide the unlock button (P, Fig 2) to
the side and by using the handgrip,
push the cutting head slowly and
evenly downwards.
Push the motor head forward in a
slow steady motion to complete the
cut.
Release trigger to stop the motor.
The cutting head must be returned
carefully to its starting position after
cutting.
Attention:
The condition of the blade should be
checked before each machining
process.
Work only with a sharp and flawless
sawblade.
Use the workpiece clamp (E, Fig 1).
Use a suitable fixture to prevent
round and irregular shaped timber
from turning under the pressure of the
cut.
Cutting wrapped material:
Wrapped or bowed material should
be positioned so that the workpiece is
supported near the cutting point by
the workpiece fence (Fig 6).
Fig 6
This operation is potentially
dangerous (Fig 7).