Jet JSG-6DC, Operating Instructions And Parts Manual, Page: 10 / 28

10
Unpacking
Open shipping carton(s) and check for shipping
damage. Report any damage immediately to
your distributor and shipping agent. Do not
discard any shipping material until the Sander is
assembled and running properly.
Compare the contents of your carton(s) with the
following parts list to make sure all parts are
intact. Missing parts, if any, should be reported
to your distributor. Read the instruction manual
thoroughly for assembly, maintenance and
safety instructions.
Contents of Main Carton
See Figure 8.
1 Belt/Disc Sander (A)
1 Belt Sanding Table (B)
1 Disc Sanding Table (C)
1 Miter Gauge Assembly (D)
1 Workstop Assembly (E)
2 Lock Knobs (F)
1 Belt Tensioning Handle w/ Nut (G)
1 Table Lock Handle (H)
1 12-inch Abrasive Disc (I)
1 6 x 48-inch Abrasive Belt (J)
1 Operator’s Manual (not shown)
1 Warranty Card (not shown)
1 Hardware Bag (K), containing:
1 Hex Key, 6mm
4 Hex Cap Screws, M10 x 80
9 Flat Washers, M10
4 Lock Washers, M10
4 Hex Nuts, M10
Figure 8