Jet JOVS-10, Operating Instructions And Parts Manual

Page: 9 / 20

9
Mounting Sanding Sleeves
1. Thoroughly clean the arbors (A, Figure 1) on
all of the spindle assemblies. Also clean the
arbor housing on the sander.
2. Slip the sanding sleeve (B, Figure 1) over
the spindle and hold in place by tightening
the set screw (C, Figure 1) with the supplied
2mm hex wrench.
3. Repeat for all of the steel spindle
assemblies.
4. To protect the sanding assemblies place
them in the holders found on the sides of
the sander. See Figure 2.
Installing Sanding Assemblies
Disconnect the sander from
the power source when installing or
removing sanding assemblies. Failure to
comply may cause serious injury.
1. Thoroughly clean the arbor and arbor
housing before installing the sanding
assemblies.
2. Thread the arbor (A, Figure 3) into the arbor
housing (B, Figure 3).
3. Use the provided wrenches to hold the
lower arbor housing nut (C, Figure 3) while
turning the arbor nut (D, Figure 3)
clockwise.
Removing Sanding Assemblies
1. Disconnect the sander from the power
source, unplug.
2. Use the provided wrenches to hold the
upper arbor housing nut (E, Figure 3) while
turning the arbor nut (D, Figure 3) counter-
clockwise.
Figure 1
Figure 2
Figure 3