6
Workpiece handling:
Support long workpieces with helping
roller stands.
During cutting operation the
workpiece must be locked against the
fence with the workpiece clamp.
Do not perform any operation
freehand.
Operating hints:
Always observe the safety
instructions and adhere to the
current regulations.
Ensure that the saw blade protective
cover is in the correct position before
you start sawing.
The mitre saw is switched on by
means of the trigger button that is
situated on the inside of the handgrip
(M, Fig 2).
The cutting blade must first reach the
maximum rpm before cutting may
begin.
Slide the unlock button (A, Fig 1) to
the side and by using the handgrip,
push the cutting head slowly and
evenly downwards.
The cutting head must be returned
carefully to its starting position after
cutting.
Attention:
The condition of the blade should be
checked before each machining
process.
Work only with a sharp and flawless
sawblade.
Select saw blade in relation to
material to be cut.
Use a suitable wedge to prevent
round timber from turning under the
pressure of the cut
Take care when slotting.
Laser Beam:
The laser beam allows you to
precisely line up your workpiece.
The laser beam can be switched on
and off as required (S, Fig 13).
Attention:
Class 2 Laser Product
Do not stare into beam of laser.
Do not point the laser beam at people
or animals.
Do not use the laser beam on highly
reflective materials. Reflected light is
dangerous.
Cutting profiles:
Profiles can be cut.
They should be cut in such a way that
the blade is cutting through the
smallest possible cross section first
(Fig 5).
Fig 5
This operation is potentially
dangerous (Fig 6).
Fig 6
Cutting wrapped material:
Wrapped or bowed material should
be positioned so that the workpiece is
supported near the cutting point by
the workpiece fence (Fig 7).
Fig 7
This operation is potentially
dangerous (Fig 8).
Fig 8
Bevel cutting:
Bevel angle can be adjusted between
0° and 45°.
Fig 9
The locking knob (C, Fig 9) on the
rear of the machine must be loosened
for bevel setting.
Tilt the cutting head to the left until
the desired angle on the scale (B)
has been reached.
Retighten the cutting head lock knob
(C) before machine operation.
Mitre cutting:
The mitre angle can be adjusted
between -46° and +46°.
The 2 table locking knobs behind the
fence must be loosened.
Rotate the cutting head until the
desired angle on the table scale has
been reached.
Retighten the table locking knobs
before machine operation.
Mitre bevel cutting:
Select the correct bevel and mitre
angles.
7. Setup and adjustments
General note:
Setup and adjustment work may
only be carried out after the
machine is protected against
accidental starting by pulling the
mains plug.