14
Blade Tension
See
Adjusting the proper Blade Tension
on page 16.
Limit Switch Adjustment
Refer to Figure 12.
The J-9225 bandsaw should shut off automatically
when a cut is completed. If not, the limit switch
probably needs to be adjusted as follows:
Disconnect the cut-off saw from
its electrical power source.
1. Place the saw in the lowered position to repres-
ent the completion of a cutting operation
2. Using a crosspoint screwdriver and 5/16" wrench,
loosen two
mounting screws
(A).
3. Position
the
limit switch assembly
(B) to actuate
to the off position as it presses against the
back
plate
(C) of the control panel when the saw has
cut through the workpiece.
Figure 12
Summary of Contents for J-9225
Page 23: ...23 Saw Assembly Drawing 1 of 3...
Page 24: ...24 Saw Assembly Drawing 2 of 3...
Page 25: ...25 Saw Assembly Drawing 3 of 3...
Page 27: ...27 Electrical Box Assembly...