9
Closed Stand Assembly (Optional)
Mount the belt rack to the stand by inserting the
90° bend through the stand and securing the rack
in place with a hex cap bolt, and a flat washer.
Sander Assembly
Machine is heavy; use care
when lifting out of the shipping carton and
moving to a final location. Stand or bench must
be stable enough to support weight of
machine.
1. Move the sander to a workbench or one of
JET’s optional stands. Bolt the unit firmly to
secure in place. (See page 7 for hole spacing.)
JET’s closed stand
uses four 3/8”x3” hex cap
bolts, four 3/8” lock washers, eight 3/8” flat
washers, and four hex nuts provided with the
stand.
JET’s open stand
uses four 3/8”x3” hex cap
bolts, four 3/8” lock washers and eight 3/8” flat
washers, and four hex nuts provided with the
stand.
2. Mount the sanding disc table assembly (A, Fig.
1) to the sander base. Insert the rod (B, Fig.
1) into the base and secure in place using the
5/16” handle (C, Fig. 1). The handle should
tighten against the flat portion of the rod.
3. Mount the sanding belt table (A, Fig. 2) to the
sander with two 5/16”x1-1/4” locking handles
(B, Fig. 2), two 5/16” flat washers. The handle
stud needs to go through the upper slot, and
the guide pin (C, Fig. 2 & Figure 3) located on
the sander should rest in the lower slot.
Note:
The belt table can be removed and the
disc table can be used in its place. There are
two holes in the base, below the sanding belt,
that will accommodate the disc table’s support
rod and locking handle.
Figure 1
Figure 2
Figure 3
