7
Figure 3
5.4
Assembling stand
Refer to Figure 3.
NOTE: Only make fasteners hand-tight at this time.
They will be fully tightened after band saw has been
settled atop stand.
1. Assemble legs, cross braces, front panel and
shelf, as shown in Figure 3. The braces on the
shelf will face upward as shown.
2. Install handle (H) into end of assembled stand.
3. Install axle and wheels on right side of stand.
Use two flat washers between wheel and stand
leg on each side. Insert cotter pin (HP3) at each
axle end and bend prongs to secure.
4. Install adjustable feet (C) at opposite end of
stand and adjust until stand is level.
5.5
Mounting saw to stand
Saw is heavy; two-person lift.
1. With help from another person, position saw
atop stand, and secure with socket head cap
screws and washers (HP2/5/6, Figure 3).
2.
Fully tighten
all fasteners on stand assembly.
5.6
Additional assembly
1. Remove shipping bracket (P, Figure 4) and
adjust switch trip (Q) so that it will turn off switch
when bow reaches down position. (Note: Switch
trip is bendable for optimum positioning.)
Figure 4
2. Install handwheel (J, Figure 5) onto vise lead
screw, and tighten set screw.
3. Install workstop rod (G) into hole and tighten set
screw (G
1
). Slide work stop on rod and secure
with set screw.
