90-852396 MAY 1996
PUMP UNIT - 5-19
15. Rotate pinion shaft back and forth lightly to con-
tact gear teeth in each direction.
NOTE: Average total amount of reading of indicator
backlash specification is .007 inch (.18 mm) to .009
inch (.23 mm).
•
If reading is less than minimum, add shims be-
tween impeller cover and drive housing.
•
If reading is more than maximum remove shims
between impeller cover and drive housing.
•
Ratio of backlash reading to shims is 1:1.
16. Install impeller, wear ring and stator as outlined
in “Installing Impeller” in this section.
17. Apply RTV Sealant (92-809825) on rideplate.
Install rideplate. DO NOT reuse screws. Apply
Loctite 242 to threads of new screws. Torque to
75 lb. in. (8.5 N·m).
18. Install nozzle/reverse gate assembly and anode.
Apply Loctite #271 to threads of screws. Torque
all four (4) screws to 35 lb. ft. (47 N·m).
19. Remove fill and vent screws from bottom of drive
housing. Fill drive housing with High Perfor-
mance Gear Lube. Capacity is 27 oz. (825 cc).
28272
a
b
c
a - Fill/Drain Screw
b - Vent Screw
c - RTV Sealant 92-809825
NOTE: To obtain correct oil level pump housing must
be level and upright.
REFER TO SECTION 1D: SPORT JET INSTALLA-
TION TO COMPLETE INSTALLATION OF DRIVE
HOUSING, SHIFT AND STEERING CABLE INSTAL-
LATION AND ADJUSTMENT.
Summary of Contents for 91-809957A1
Page 1: ...5 28237 JET PUMP ...
