Installation, Operation, & Maintenance Instructions
IOM J500.35
2021.04
JMT
● +1.440.572.1500
13
4.2.5 User Installation
Level Units
The JMT will come preprogrammed to the desired user
installation. If however it is desired to change any of these
settings, they are done so through this menu.
Level Units
Selection between units, if this is changes it will propagate, and
show the units across the values to be entered for all properties.
Inches
XXX.XX
(Two Decimal Places)
Feet
XX.XXX
(Three Decimal Places)
Millimeters
XXXXXX
(No Decimal Place)
Centimeters
XX.X
(One Decimal Place)
Meters
X.XXX
(Three Decimal Places)
1/16
Of a Foot
XXXX.XX
(Two Decimal Places)
Use
Up
and
Down
to select desired Engineering Units to be
displayed. Then press
Enter
to move to next screen.
Level Offset
This is a user value for if they have a need to report a level
offset from the measured level. Typically, this is the distance
from the lowest point the sensor can measure, to the bottom of
the tank, or any zero-reference point lower than end of the
Magnetostrictive sensing element. Use
Up
/
Down
(or
Back
to
change position) and
Enter
to move to next screen.
Note: Offset cannot be Sensor Length.
Vessel Tag
This is an 8-character tag that can be used to name the
instrument for the operator. If set, this tag will be displayed on
the
Main Operating Screen
. This is a distinct tag from the
HART tag, which can only be set via HART.
Long press of the
Up
or
Down
buttons scrolls quickly through
the alpha-numeric selection.
Enter
sets each place’s value.
Once tag is set, press
Enter
as needed to close out the screen,
Note that the vessel tag will only be displayed if the first
character is changed.
