Jenx
1. Important Safety Information
What
’
s in this booklet?
The following information is for the benefit of you, the carer and the user of this
Medical Device, therefore please read thoroughly before using the Device.
This product must be thoroughly inspected by a qualified person at least annually
Ensure that your Therapist has confirmed that the product is correctly set up, by signing the ‘Set
Up’ section of the Log book before using this product. If the product has not been set up by your
Therapist DO NOT USE.
Jenx Ltd. recommends that children are never left unattended whilst using this Medical
Device. Children may slip or fall when unattended and may suffer serious injury. It is the sole
responsibility of the person caring for a child using this Medical Device to ensure the safety
of the child in the Device should they be left alone.
Always read the instructions before operating. Failure to read and follow the Instruction for Use,
especially with regard to moving parts, may pose a risk to the user.
Do not use this product if you suspect or know that it is broken or faulty.
Please contact your supplier.
This product contains small parts which could present a choking hazard to small children.
All Jenx Ltd. products are tested to meet current Fire Safety regulations. Always keep
products away from; naked flames, cigarettes and sources of heat such as heaters.
Assemble product fully before use. Please contact your supplier if you have any problems.
Ensure that good care is taken of your product: clean regularly. Do not use abrasive cleaners.
When not in use, store this product in a dry place that is not subject to extreme temperatures.
Please DO NOT store this product in garages, attics or garden sheds.
All belts and harnesses should be used at all times. For therapy purposes it may be necessary
to deviate from this rule and any deviation should be fully documented as part of a Risk
Assessment or Therapy Program and all relevant staff and carers appropriately trained. Secure
user with straps before adjusting product. Ensure there is a finger’s width between safety strap
and user to prevent over tightening or user moving to inappropriate position. Adjust straps for
each user and changes of clothing. Minimum Velcro® overlap: 3 inches (7.5cm) on all straps.
If strap is not long enough: DO NOT USE PRODUCT.
This product conforms to the European Medical Devices Directive. It has not been tested in
conjunction with other manufacturer’s products. Do not add any accessories other than Jenx
Ltd. accessories to this product. If in doubt, contact your supplier.
Any changes or alterations carried out by persons other than a Jenx Ltd. authorised service
person will invalidate the warranty and Jenx Ltd. can accept no liability for any injury or
damage so caused.
All Jenx Ltd. products are Medical Devices and are sold on the understanding that they will be
prescribed, issued and maintained in line with current national device management guidelines.